Now again Go to the section of Network Connections, right-clicking on the same cell as the last time, select Enable (activate) can once again, to make sure your browser to try to open any web page. Now, if the browser was unable to access web page, then you define an adapter that you need. Thus, determining or already knowing what the computer uses an adapter to connect to the Internet, click on the right mouse button and choose Properties. The box idea is to find words Internet Protocol (TCP / IP), click on them with the mouse to select them (just do not accidentally uncheck the box, which on the contrary). Then click the Properties (the Properties). Note the contrast: Use the following ip address: and Use the following dns server addresses: and enter the information you were discharged earlier from Command Prompt, respectively: ip Address > ip Address Subnet Mask > Subnet Mask Default Gateway > Default Gateway dns Servers > dns Servers in the Command Prompt If you have been assigned only one ip address for dns Servers, then fill it in front of Preferred dns server:, but on the contrary Alternate dns server: leave blank. Sometimes this information can be extracted from the router to Both dns Servers, for both the Preferred (Main), and for the Alternate (Secondary), but Fritz! Box does not have such information. Note that in the framework for entering addresses is arranged dots, so that you do not have to make. Hear from experts in the field like technology investor for a more varied view.
True, using the default gateway address and ip Address your computer, you can calculate the address, which router (ie, dynamic ip address of the server) is not normally issued. To once again failed lining. That is, if you have multiple computers at home or on the the case when your neighbors connect to your router. If you create a static ip, each computer must be assigned an individual ip Address, and Subnet Mask, Default Gateway and dns Servers are the same. Upon completion of entering information – click ok. In the remaining box, click Close. Your computer has a static ip.